Nammor Repair

[SaintPendulous]

i was gettin ready to clean my nammor, so i pulled the mouthpiece out and it came out with a rubber grommet, and i cant get it to go back in and stay in

i tried to just jam it back in and it wouldnt stay, i found out i can roll back the fuzzy part for better access to where the piece fits in but i cant get it to stay in, i tried wrappin a single layer of duct tape over the end of it but it wouldnt stay, i dont have glue, i tried holding a lighter to the open end of the hose to see if there was any glue i could reheat

i jamed it back in sorta successfully and i think ill wait till tomorrow to see how it works



Anybody have any idea how to fix it??

[Travis]

Wrap some electrical tape around it. Then shove it in there like its nobody's business.

[Chreees]

^Exactly what Travis said. I have electrical tape all up on mine.

[indian_villager]

Use Gorilla Glue. if you look around the how to section there will be a few of my write ups on how to repair a Nammor/Razan hose.

[ih303]

I generally wrap the grommet with electrical tape to make it fit better, put it together, then wrap the seam with more electrical tape. Works like a charm.

[Stuie]

put the grommet back on the tip.
put a few drops of superglue on the grommet.
shove back into the the hose
Ready to roll out thunderous clouds in 15 mintues

[hookah hippie]

I fixed one with gorilla glue awhile back it still holds together