Jump to content

Mya Gyro Econo


Recommended Posts

take the ball bearing out of the purge cap and clean the entire area. i always had trouble purging mya's due to the open chamber as opposed to closed chamber construction
Link to comment
Share on other sites

There's definitely something wrong with the purge valve. Do as Iain suggested. You should be able to open it up and remove the bearing, cleaning everything thoroughly. It may be different on the Econos, however, as I have no experience with them.
Link to comment
Share on other sites

something i've found that works better then the bearings on the myas since i have a lot of myas is using a small water ballon, cut the end off of it just the tip and put it over instead of the ball and it should work like i champ i use it on my mya works better then the bearing and seals better

[IMG]http://img.photobucket.com/albums/v684/Blitzbolt/72aafc98.jpg[/IMG] Edited by Pavo21
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...