Yoner Posted March 27, 2007 Share Posted March 27, 2007 Now, I'm probably wrong about this but....I purchased 2 MYA hoses from mnhookahhttp://mnhookahs.com/product_info.php?products_id=95When I first saw them, I knew something was amiss. I could tell they wouldn't fit into my QT. Now, are there special hoses for just the QT?The one on the left is from directly MYA. The one on the right is from mnhookah. The grommet direct from MYA doesn't even fit over the tip from the one from mnhookah. What gives?If I'm wrong I'll gladly eat crow, but something's not right. Link to comment Share on other sites More sharing options...
Hookah_Bob3 Posted March 27, 2007 Share Posted March 27, 2007 That should fit..I have a Mya wide that fits into my QT..You can just stretch the grommet over the end Link to comment Share on other sites More sharing options...
Yoner Posted March 27, 2007 Author Share Posted March 27, 2007 Got it. I'll try it out. Link to comment Share on other sites More sharing options...
Yoner Posted March 27, 2007 Author Share Posted March 27, 2007 Boy, that crow sure does taste good. I stand corrected. Link to comment Share on other sites More sharing options...
MN Hookah Posted March 27, 2007 Share Posted March 27, 2007 Yoner,These hoses are directly from mya we get all our mya products from myasaray so everything should be correct.TarikMN Hookah Link to comment Share on other sites More sharing options...
Yoner Posted March 27, 2007 Author Share Posted March 27, 2007 Yeah I'm a schmuck. Sorry. Link to comment Share on other sites More sharing options...
Scheetz Posted March 27, 2007 Share Posted March 27, 2007 LOL yeah, not every stem is going to be the same. But they will all fit no matter what. Just need to work it in like you did. Link to comment Share on other sites More sharing options...
Lakemonster Posted March 27, 2007 Share Posted March 27, 2007 the wooden ends on the MYA hoses as with any other hose will vary from time to time.... most likely the mill that lathes these things out is using a simple duplication device that attaches to the lathe... it uses an actual hose end to duplicate the new one being cut... these pieces they use on the duplication end can wear down over time making some of the tips smaller than ones from an earlier batch. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now